Coating production line refers to metal or non-metal surface smear some appropriate protective layer, in the past when they are used is handmade, and now with the development of society, has begun to be automated, so, Tu equipment production line is now beginning to be widely used in many of the fields, then take a look at considerations when coating production line work. First: the coating production line at work, take note issue for racking products to be coated in advance is necessary to choose some appropriate rack, this rack is through trial and dip to the overall design, The ultimate goal of this approach is the ability to allow the workpiece to be coated in an optimal position, apply the effect will be better, will be more smooth. Second: the use of coating production line when it is very prone to paint solvent diffusion in the work shop, but also a lot of gray paint layer will fall into the tank, in order to avoid this from happening, in the work of when the whole dipping tank needs to be protected up. Third: to be coated product sizes automatic powder coating equipment recycling, some large items, some small objects painting equipment Bag Recycling, here to remind you to pay attention to the problem, if large objects were painted When installed, pay attention until after the volatile solvent completely, and in the implementation of the next step to further processing drying room inside. First, the preparatory work before 1, the gas source is connected to the fast interface sprayer; 2, take a good cure powder barrel below the gas source; 3, the powder barrel debris clean; 4, will clean the powder down powder coating equipment into the barrel, height does not exceed 3/4 of the height of the powder keg; 5, take a good powder overflow pipe; 6, connect the power and ground and ground spraying with the full contact of the workpiece. Second, a spraying operation specification, the power source open air; 2, turn the knob so that the powder barrel fully cured powder in suspension; 3, the static power is on; 4, the potentiometer knob clockwise to (80-140) μA ; 5, the left side in the boot state electrostatic filter regulator second table (secondary air) raised 1-2Pa; 6, above the first surge table (a gas) is adjusted to fit 2-4Pa application amount of powder; 7, spray painting equipment grip switch machine gun to move away from the workpiece 10-15cm position; 8, request from the inside to the outside or by the angle between the plane spraying order to; 9, horizontal and vertical spray evenly reach powder layer uniformity and thickness; 10, check the layer must not have pinholes, ionization pits, orange peel, and sewage leak spray variegated pink, uniform color layers to reach consensus; 11, prohibiting the use of the whole operation with lint fiber layer gloves after touching the workpiece is suspended bake at reasonable intervals. Painting equipment pre-treatment systems, painting equipment, painting equipment provided by Sino Sino Painting Equipment Co. Qu. Qu Sino Painting Equipment Co. (www.wfjn.com) (www.wfjn.com) (www.wftcsw.com) strong, credible, Shandong Weifang industrial automation control systems and equipment industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead Sino painting equipment and you hand into the brilliant, for a better future!